EUR
Your position: Home / Auto Key Programmer
Item No.
KEY0061
Item Name.
ID Card Copying Machine 125Khz Keychain Low Radio Frequency Card Access Control Elevator Rental House Attendance Card Copying Machine
Related Products
-
$ 500.00Add To Cart
$ 500.00
-
$ 75.00Add To Cart
$ 75.00
-
2019 Autek Bosscom KMAX-850 KMAX 850 KEY PROGRAMMER With VAG 4th and 5th immo systems and MQB system$ 950.00Add To Cart
$ 950.00
-
$ 240.00Add To Cart
$ 240.00
-
$ 500.00Add To Cart
$ 500.00
-
$ 85.00Add To Cart
$ 85.00
ID Card Copying Machine 125Khz Keychain Low Radio Frequency Card Access Control Elevator Rental House Attendance Card Copying Machine
Contact Me With Whatsappproduct manual:
Frequency: 125KHZ protocol can support ID
Card: Support writing to T5577, EM4305, CET5200 and all T5577, EM4305 compatible cards
Distance: The reading distance of the keychain can reach 2.5CM, the card can reach 6CM
Size: 71*117*31mm
Power supply: Two AAA batteries can be used 20,000 times
Introduction:
The 125KHZ handheld is a device used to make the same card number as the mother card. It uses a mini handheld shell, which is ergonomic and easy to carry. It uses the silicom international advanced chip, and all work is done by this chip to make the product integrated. Higher, more stable and reliable;
The use of excellent program algorithm and circuit design reduces the power consumption of the product and prolongs the service life of the battery; the design of a read button and a write button makes the operation easier; it can copy the ID4100 card and can penetrate part of the firewall.
Instructions:
1. Start the device
1. Push up the switch on the right side of the device, the red light is on, and the green and yellow flashes at the same time, indicating successful startup, otherwise restart it once.
2. After the device is started, do not read any card at this time, and then press the device write card button to write the card as an all-zero ID card. After the card is successfully written, the buzzer will beep twice and the green light will be on.
3. When any button is pressed, the yellow light is on, indicating that the device is working.
Second, read and write cards
1. Push up the switch on the right side of the device, the device will beep 2 or 3 times, and the green and yellow lights flash at the same time to indicate successful startup;
2. Put the line card in the antenna position on the left side of the device, press the card reading button, the device will beep twice to indicate that the card reading is written, and the green light is on;
3. Change to a new card and press the write button. The device beeps twice to indicate that the card was successfully written, and the green type is on, indicating that the card is successfully written.
5. Put one writable EM4305 key on the back side of the copier and press "Write"
